LMS 4.2.3 and CAAM

[millerca]

When attempting to run a compliance report for a 3750G, I receive a message stating:

"The report cannot be generated for the selected devices.

Probable causes:

1. Selected devices are not applicable for this report.

2. Device details (inventory or running configuration or show command output) may not be available to generate the report."

Any ideas as to how to determine which of the above is the reason?

Thanks,

Curt

[Marvin Rhoads]

Which compliance report are you trying to run? I think almost all should be applicable to a 3750G switch. I know I've run against various 3k models just fine (though don't have a 3750G in my lab to check).

I'd look in Device Center and verify that you have an inventory and configuration file gathered for that device.