I'm trying automatic discovery with Ping on sweep module. I'm using the following configuration (you can also see it in the attached file):
discovery module - ping on sweep
global seed device - 192.168.6.35
preferred DCR display name - DNS resolvable hostname
The LMS server has its hostfile populated with the device ip/hostname that i'm testing with and resolving from the server works in both directions. Nevertheless, after discovery proccess is finished, the device is added in DCR with its IP address as dispaly name (screenshot in the attached file).
I've tried the same method in CiscoWorks 4.0.1 and it works fine.
I'm attaching the debug log files from discovery test. The LMS is running on Windows Server 2008 standard
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access for Distributed C...
Dear All, When I use the show interface command on the Cisco Router ISR-4331, it will display as below information. The word that I mark red, it refresh every 5 seconds. But, I compare with the old router model like a Cisco 29XX or 28X...
Whether you're attending VMworld 2019 on-site or from afar, read the latest on the key themes to expect. They are also the key themes for IT management today, from software defined everything to cloud and automation to IoT and edgecomputing : http:...