i'm working with Cisco Prime LMS 4.2.0, i have a problem to manage Nexus series, the switchs are well discovered but i can't fetch config, view ports, the modules not presents int the chassis are all in error. when i add the devices, every L3 interfaces are added as a separate switch. The User tracking doesn't work through the Nx (but it seems it's normal for UTU as i saw)
thanks for the reply, i will start with one problem and open a new case for the others.
my main problem is :
when i add the nexus, it works, i can read snmp informations, fetch config and so on. but i have a lot of alarms about the card not plugged into the chassis, and i get 50 alarms by Nexus (more or less).
when i go to the "fault device detail" to tune the alarms, i see all the cards not plugged (not present) but i can't say "Don't monitor that" like i could do with an interface, for example.
so how can i esume these alarms without simply clear it ?