cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
579
Views
5
Helpful
3
Replies
Ibrahim Jamil
Frequent Contributor

LMS 4.2 | Takes time to re-mention the Device Reachable

Hi Netpro

I ve recognized some strange issue with LMS 4.2 , when the router becomes down or unreachable , the LMS doesn't send any event as Faultview,also when the router comes back online the LMS takes 1 hour to show its state as  reachable , how can i fix this Behavior?

thanks

jamil

3 REPLIES 3
Marvin Rhoads
VIP Community Legend

Are you looking at the Topology map? That's not designed to be a real-time network status map - it reflects the status based on the ANI polling cycle (default = 2 hours).

The Fault Management Dashboard should reflect device status based on the Fault polling cycle (can range from 30 seconds to one hour, configured according to procedure in Chapter 3 of the Monitoring Guide)

thanks a lot  Mr.Marvin

please mark question answered