cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1780
Views
0
Helpful
2
Replies

LMS 4, snmpv3 - Error performing SNMP operation

Reidar
Level 1
Level 1

Hi

I have a cat 3750 switch with the folowing snmp v3 config:

snmp-server group admin v3 priv

snmp-server user lmsadmin admin v3 auth md5 password1 priv aes 256 password2

The credentials on the device in LMS are as folowing, where Auth. password = password1 and private password = password2:

snmpv3.PNG

When I run a credentials verification job, I get the following error message:

Error performing SNMP operation.

I have tried this on LMS version 4.0 and 4.1 with the same result. What am I doing wrong? Any ideas?

1 Accepted Solution

Accepted Solutions

Michel Hegeraat
Level 7
Level 7

You have given SNMP read access on the device(s). If you give readwrite the "fault" shoud go away.

Cheers,

Michel

View solution in original post

2 Replies 2

Michel Hegeraat
Level 7
Level 7

You have given SNMP read access on the device(s). If you give readwrite the "fault" shoud go away.

Cheers,

Michel

Thank you.

After adding the folowing config it worked:

snmp-server group admin v3 priv write wr

snmp-server view wr iso included  <-- didn't work without this line

Regards

Reidar

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: