cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1727
Views
4
Helpful
1
Replies

LMS RME Config Mgmt Partially Successful

Wassim Aouadi
Enthusiast
Enthusiast

Hi,

From the various posts around here, I read that, in Config Mgmt, LMS connects through Telnet or SSH to devices, then uses TFTP to send configs.

In my network, I run SSH on my devices. Device Credentials Verification Job is successful for sw1 and sw2, which by the way are Catalyst 4948. However, in Config Mgmt, they are displayed as Partially Successful.

I wanted to test manually by connecting to the device through SSH then issuing TFTP copy. I found that "vlan.dat" is not under Flash; it's under  Cat4000_flash.

So how do I tell LMS to fetch under Cat4000_flash instead of Flash, for this model of switches?

thanks

1 Reply 1

Joe Clarke
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

Have a look at this thread:

https://supportforums.cisco.com/thread/2087520

Don't worry about the cat4000_flash.  RME knows to use that file system.  So make sure that manual TFTP copy works.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers