Hi,
From the various posts around here, I read that, in Config Mgmt, LMS connects through Telnet or SSH to devices, then uses TFTP to send configs.
In my network, I run SSH on my devices. Device Credentials Verification Job is successful for sw1 and sw2, which by the way are Catalyst 4948. However, in Config Mgmt, they are displayed as Partially Successful.
I wanted to test manually by connecting to the device through SSH then issuing TFTP copy. I found that "vlan.dat" is not under Flash; it's under Cat4000_flash.
So how do I tell LMS to fetch under Cat4000_flash instead of Flash, for this model of switches?
thanks
