10-10-2019 04:43 AM
Hi,
On a catalyst VSS switch, I can connect with the username toto (privilege 0) but I don't have the enable command available to change the configuration. The configuration file is like :
username toto privilege 0 ....
privilege exec level 15 enable
The problem is that now we have lost the possibility to modify, to see the running config.....
2 ideas to solve it :
1/ Password recovery process, but I'm not sure it will be ok because we have the password, but not the possibility to be enable
2/ Factory reset...but a little dangerous.
Does anybody know another way more convenient to solve this problem ?
Thanks
Best regards
Gilles
Solved! Go to Solution.
10-10-2019 05:36 AM
Hi,
Do you have any other usernames on the switch? Is your console port also asking authentication?
If not then go with the password recovery process and you will get access to the switch configuration mode, where add new user or increase privilege to this user.
10-10-2019 05:36 AM
Hi,
Do you have any other usernames on the switch? Is your console port also asking authentication?
If not then go with the password recovery process and you will get access to the switch configuration mode, where add new user or increase privilege to this user.
10-10-2019 09:25 PM
are you using local authentication? If yes then I really suggest you consider configuring AAA and setting up Cisco ISE. Then you wouldn't have to deal with separate usernames and passwords on switches.
Do you remember if it was enable or enable secret? If enable then a backup of the config can help you as Cisco type 7 password can be easily cracked. If not then password recovery can be the solution:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: