cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1765
Views
0
Helpful
1
Replies

Measure telephone traffic on an ISDN PRI

vschallenberg
Beginner
Beginner

Has anyone developed an EEM Scrip to measure telephone traffic on an ISDN PRI interface on a voice gateway?  Preferably the traffic measurements would be in Hundred Call Seconds (CCS) or Erlangs. It would appear that the “show isdn service” command could be used to determine the state of the individual “B” channels on the PRI.

1 Reply 1

Joe Clarke
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

If the "show isdn service" command gives you what you want, then you could build a policy using the timer event detector (watchdog timer) to run the command periodically and produce the desired reports.  I don't know of anyone that has already done this, though.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers