11-04-2018 12:53 PM
hello all
i have 3 internet connections and i have a 4331 as my router and i have a 3850 as my switch i have connected my internets to my switch and gave them each there own vlan 500,501,502 and connected my switch to my router via a trunk link with allows only said VLANs and i have created 3 subinterfaces with the same VLANs on each and configured 3 dialer interfaces but my issue is only one comes up the other two keep restarting how can i fix this issue ?
this is my switch:
interface GigabitEthernet1/0/37 switchport access vlan 500 switchport mode access switchport nonegotiate ! interface GigabitEthernet1/0/38 switchport access vlan 501 switchport mode access switchport nonegotiate ! interface GigabitEthernet1/0/39 switchport access vlan 502 switchport mode access switchport nonegotiate ! ! interface GigabitEthernet1/0/42 switchport trunk allowed vlan 500-502 switchport mode trunk switchport nonegotiate speed 1000 duplex full !
this is my router :
interface GigabitEthernet0/0/1 no ip address negotiation auto ! interface GigabitEthernet0/0/1.500 encapsulation dot1Q 500 pppoe enable group global pppoe-client dial-pool-number 1 ! interface GigabitEthernet0/0/1.501 encapsulation dot1Q 501 pppoe enable group global pppoe-client dial-pool-number 2 ! interface GigabitEthernet0/0/1.502 encapsulation dot1Q 502 pppoe enable group global pppoe-client dial-pool-number 4 ! ! interface Dialer1 ip address negotiated ip nat outside encapsulation ppp ip tcp adjust-mss 1452 load-interval 30 dialer pool 1 dialer-group 1 ppp authentication chap pap callin ppp chap hostname **** ppp chap password 0 **** ppp pap sent-username **** password 0 **** no cdp enable ! interface Dialer2 ip address negotiated ip nat outside encapsulation ppp ip tcp adjust-mss 1452 shutdown dialer pool 2 ppp authentication pap chap callin ppp chap hostname **** ppp chap password 0 **** ppp pap sent-username *** password 0 **** ! interface Dialer4 ip address negotiated ip nat outside encapsulation ppp ip tcp adjust-mss 1452 shutdown dialer pool 4 dialer-group 4 ppp authentication pap chap callin ppp chap hostname *** ppp chap password 0 *** ppp pap sent-username *** password 0 *** !
can any one help me on this
11-04-2018 07:19 PM
Hi,
I can see that Dialer 2 and 4 are forced to shut down using the "Shutdown" command.
interface Dialer2 ip address negotiated ip nat outside encapsulation ppp ip tcp adjust-mss 1452 no shutdown dialer pool 2 ppp authentication pap chap callin ppp chap hostname **** ppp chap password 0 **** ppp pap sent-username *** password 0 **** ! interface Dialer4 ip address negotiated ip nat outside encapsulation ppp ip tcp adjust-mss 1452 no shutdown dialer pool 4 dialer-group 4 ppp authentication pap chap callin ppp chap hostname *** ppp chap password 0 *** ppp pap sent-username *** password 0 *** !
Run above-highlighted commands under each dialer interface.
Regards,
Deepak Kumar
11-04-2018 11:05 PM
thanks but the issue continues i have shut them down so my primary connection stays up
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: