cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
481
Views
0
Helpful
2
Replies
ivana.kvaka
Beginner

Nested policies level limitation in QPM

Hi,

I have QPM 4.1.5 installed. Here is simplifed example of QoS config on a router.


interface GigabitEthernet0/1.222
service-policy output LEVEL1


policy-map LEVEL1
class class-default
service-policy LEVEL2


policy-map LEVEL2
class 1
  shape average 10000000
  service-policy LEVEL3a
class 2
  shape average 4000000
  service-policy LEVEL3b


policy-map LEVEL3a

class 3

class 4

class 5

...


policy-map LEVEL3b

class 6
class 7
class 8

...

In QoS Report Card I can see only 3 classes.

default
class 1
class 2


There are no classes from LEVEL3 service policies. Is that QPM discovery limitation? Do you have experience with this?

regards,

Ivana

2 REPLIES 2
Nael Mohammad
Contributor

Is this occurring on all devices? What kind of device is having the problem? QPM limitation is 12 classes per interface so you could be running into a bug.  Try running a device update from Common Services --> Software Center --> Device Update and update all the packages.

Post the show ver of the device having this problem and a screen shot of the Common Services --> Software Center --> Software Update page.

Hi,

Is this occurring on all devices? What kind of device is having the problem?

Just on Cisco 3845 that has level 3 policies applied


QPM limitation is 12 classes per interface so you could be running into a bug

I have qpm 4.1.5 installed where this bug should be resolved?

Show ver and screenshot in attachment.

Thank you,

Ivana