We have configured netflow on our Cisco Nexus 7009, but we have been reported that the server that is receiving this traffic, doesn't support this type of packet. We created a flow record, a flow monitor and exporter and it says it is exporting fine. But I see that we have to use a sampler:
N7KCORE2(config-if)# ip flow monitor monitorMcAfee input
ERROR: A sampler must be configured for an interface on an F2 card or F2e/F3 mixed vdc
Therefore we configured a sampler. They say that they are receiving SFLOW traffic, but they need generic netflow. Is there a way to achieve this? I cannot find another way to configure netflow on this Nexus.
Cisco Champion Radio · S7|E45 Network Insights with AI Endpoint Analytics
Identifying who and what is on the network is a challenge for many organizations. Incomplete visibility makes it difficult to implement advanced security policies and recommendatio...
HI, In the attached diagram from cisco site if we assume R101 and R102 are two DC having a layer 2 link and both are advertising same subnet (eg. 192.168.12.0/24) to the ISP i understand by using BGP metrics we can make one DC primary and other as se...
Question I am having trouble pulling DHCP from a given network. I am fairly new at DHCP servers and I am trying to understand how IP addresses work within these servers. The objective is to give DHCP to my 6 PC's on my main network. I can either...
Hello, I was doing a packet tracer lab. Everything was fine, working, then suddenly it freezed. I closed the window. Now everytime I open this file, it freezes. I uninstalled it and reinstall, still the same. Tried with an older version, keeps crashi...
Can someone share me the test cases related to SDA after migrating the site from traditional network to SDA network. what test point should be considered/tested after the migrating on SDA network. Please share the test case point.