10-31-2017 07:18 AM - edited 03-01-2019 06:13 PM
Hello all,
LMS 4.1 had a lovely feature (netshow commands), that helped us perform daily routine tasks. Currently we are running PI 3.2 (express plus). Is there a similar tool in PI 3.2.
We want to run a simple command daily on our routers, to check some routing issues. Is there a way to accomplish this via PI?
Thank you in advance,
Katerina
Solved! Go to Solution.
11-01-2017 08:27 AM
what you can use as a workaround....
create a config template and use the following (as an example)...
do show interface status
afterwards deploy the template and check the results in the job details
05-26-2019 04:05 PM
You could also use the following format in a configuration CLI template, for example:
#MODE_ENABLE
show command(s) here
#MODE_END_ENABLE
I have tested this and works fine in our Prime Infrastructure 3.4 server..
Regards..
10-31-2017 09:16 AM
(Afraid there's still no netshow)
M.
11-01-2017 03:50 AM
Thank you for the reply!
It is such a pity that the best features of LMS are not included in PI!
11-01-2017 08:27 AM
what you can use as a workaround....
create a config template and use the following (as an example)...
do show interface status
afterwards deploy the template and check the results in the job details
11-02-2017 07:36 AM
Great idea!
Thank you very much! At least I can do something with the product!
05-26-2019 04:05 PM
You could also use the following format in a configuration CLI template, for example:
#MODE_ENABLE
show command(s) here
#MODE_END_ENABLE
I have tested this and works fine in our Prime Infrastructure 3.4 server..
Regards..
05-27-2019 03:31 AM
Hi!
Thank you for the info. It works perfectly
Thanks!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: