Network design redundancy advice

[RBeugnies]

Hi all,

I have a network which requires redundancy. I need to have 2 firewalls and 2 distribution switches. 

I have come up with a design idea however I’m not sure if this is the correct way to achieve the desired results, but with that said from my knowledge I believe it should work. 

I would appreciate any comments or alternative design ideas.

[Dennis Mink]

This looks OK, as a physical/layer 1 redundancy.

you would need to add a similar diagram for layer 2 (VLANs)

and layer 3 (ip interfaces, subnets and what routing you are going to use, or potentially set the FWs up as an HA pair).