Hi I want to send configuration from NetwrokAutomation-1 to router, but I cannot. After I checked it, I found NetworkAutomation-1 cannot ping Rrouter1(R1) and even ping itself. I see every config is normal. Please see below picture. Anyone can give some suggestions?
R1#sh ip int bri Interface IP-Address OK? Method Status Protocol FastEthernet0/0 unassigned YES manual administratively down down Ethernet1/0 192.168.0.1 YES manual up up Ethernet1/1 unassigned YES unset administratively down down
Community Live- ISR1100X-4G and ISR1100X-6G Platform Overview and Architecture
(Live event - Tuesday, 23 March, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event will have place on Tuesday 23rd, March 2021 at 10:00 hrs PDT&...
Cisco Secure Network Access is helping IT to bridge the gap between what is essential to the business and what the network delivers and to build the next-generation campus network for an unplugged and uninterrupted experience.
Learn more about how these w...
(view in My Videos)
Community Live- New Additions to the Catalyst 8000 Family
(Live event - Tuesday, 23 February, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event had place on Tuesday 23rd, February 2021 at 10:00 hrs PDT...
Community Live-ISR1100X-4G and ISR1100X-6G Platform Overview and Architecture
This event had place on Tuesday 23rd, February 2021 at 10hrs PDT
Designed for an intent-based network, the Cisco Catalyst 8000 Edge Platforms family offers ...
To participate in this event, please use the button to ask your questions
New Additions to the Catalyst 8000 Family
This forum is a chance to clarify all your questions related to the Catalyst 8k Family!
Designed for an intent-based network, the Ci...