Hi I want to send configuration from NetwrokAutomation-1 to router, but I cannot. After I checked it, I found NetworkAutomation-1 cannot ping Rrouter1(R1) and even ping itself. I see every config is normal. Please see below picture. Anyone can give some suggestions?
R1#sh ip int bri Interface IP-Address OK? Method Status Protocol FastEthernet0/0 unassigned YES manual administratively down down Ethernet1/0 192.168.0.1 YES manual up up Ethernet1/1 unassigned YES unset administratively down down
In the last year, we’ve seen substantial changes in how enterprises conduct business. When the pandemic hit, it exposed gaps in business continuity plans, and it showcased the need to quickly deploy and remotely manage secure connections.
On 18th December 2020, Cisco announced the latest IOS XE release - Cisco IOS XE Bengaluru 17.4.1a
The first one in the Cisco IOS XE Bengaluru release series, IOS XE 17.4.1a unlocks various routing features and enhancements comprehensively c...
Exploring business options for a SD-WAN managed serviceLogicalis UK offers a rapid, cost effective deployment with ngenaAdvantages that make a differenceSummary of benefits:Looking forwardResources
This event had place on Tuesday 19th, January 2021 at 10...
(view in My Videos)
Community Live- May the SD-WAN Force Be With You
This event took place on Tuesday 19th, January 2021 at 10:00hrs PDT
In this session attendees received an introduction to Software Defined-WAN (SD-WAN) and the importance of ...
Cisco Champion Radio · S8|E3 The Cisco DNA Center Machine Reasoning Engine
Machine Reasoning is a new category of AI/ML that you will soon hear a lot about. It saves your IT team time by automating complex and tedious networking tasks. It can also...