In LMS 2.6, there are only two types of licenses. You either have a 300 device license or an unlimited license. If you have the 300 device license, LMS applications such as RME and DFM can only manage up to 330 devices. DCR itself is not licensed. You can technically add up to 50,000 devices to DCR. If you are adding devices to DCR, but they are not showing up, I would suspect you are integrated with ACS and, your ACS configuration is not correct. If you are integrated with ACS, check the Common Services > Device and Credentials > Reports > Devices not configured in ACS report to see if the devices show up there. If so, you will need to add these devices as network clients of your ACS server.
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...