cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1177
Views
0
Helpful
4
Replies

New to CLI - Configuring a VLAN and adding ports

SJNIII
Beginner
Beginner

I am new to CLI.

I have a 3560 24 port switch and I need to create a VLAN 10 and include ports 12-24 at 1 GB.

The 3560 shows the 24 port and the last two opening do not have a port.

I was reading the guide, and the examples show using example of FastEthernet and GigEthernet.

I am wondering if the below is correct to set up 12-24 in VLAN 10 and so that I can connect port 5 off of the Cisco switch to a port on a Dell Switch configure in VLAN 10.

 

#### create VLAN 10

Switch# configure terminal

Switch(config)# vlan 10
Switch(config-vlan)# name mdsan
Switch(config-vlan)# exit
Switch#


#### assign ports 12-24 to VLAN 10


Switch# configure terminal

Switch(config)interface range fastethernet0/12 – 24
Switch(config-if-range) switchport mode access
Switch(config-if-range) switchport access vlan 10
Switch(config-if-range) no shutdown
Switch(config-if-range) end
Switch#

#### assign port 5 as access port


Switch#
Switch# configure terminal
Switch(config)interface fastethernet0/5
Switch(config-if) switchport mode access
Switch(config-if) switchport access vlan 10
Switch(config-if-range) no shutdown
Switch(config-if-range) end

 

4 Replies 4

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

Yes, this is one method.  Another method is to add port 5 to your "interface range" command with the others, like this: 

 

interface range fastethernet0/5, fastethernet0/12 - 24

Switch(config-if) switchport mode access
Switch(config-if) switchport access vlan 10

Switch(config-if-range) spanning-tree portfast
Switch(config-if-range) no shutdown
Switch(config-if-range) end

 

Thanks

As,, a followup, are the last two ports (SFP) on the switch always set as

Gigabit Ethernet port - GigabitEthernet0/1,GigabitEthernet0/2,  for Fiber?

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

Same thing.  It'll work.  If the configurations are the same, just add the ports to your interface range command.

ok,

 

I checked and the last two ports can not be used as there are no physical ports in place, only two empty slots.

so, i will only be using ports 1-12 on VLAN1 12-24 on VLAN2

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers