not able to connect with pws prime cable provisioning
I have installed cisco prime cable provisioning in my Linux system. pws is also insatlled. I tried to connect the pws through program. but we are gerring
Unable to connect to the remote server. I generated the code from the wsdl file and used that c# file to connect.
During installation of pws the ports used were 9100 for non secure and 9433 for secure. but in the c# file(generated using wsdl) the url is showing as
this.Url = http://localhost:9090/ProvisioningPort;. I changed the local host to the Linux server name. when i tried to create a session in the webservice programatically i am getting the above said error.
the code used to connect the webservice is
ProvisioningService ps = new ProvisioningService();
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...