02-20-2021 07:34 PM
Hi team
Not able to receive ping on SG 350-28 lan switch, MAC is getting learnt while managing it from trunk port. Some issue in L3 setting need support.
02-21-2021 02:16 AM
Not able to receive ping on SG 350-28 lan switch
explain more and post config-if possible
Are you not able to get Ping from switch to device or device to switch?
10-10-2021 10:50 PM
Some issue i seen in SG350 28 Port, PoE Gigabit, Also system Led blinking try to connect over on Tera Team, Putty & Hyper terminal, it was showing garbage on screen, i tried reset but not works, Kindly advise solution.
10-11-2021 05:11 AM
system LED Blicking means ready to setup intial config.
Start from quick start guide as below :
http://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/sf30x_sg30x/quick_start/78-19252-01.pdf
Tera Team, Putty & Hyper terminal, it was showing garbage on screen
On the above document - look at Use the console port ( baudrate)
10-11-2021 05:58 AM
10-11-2021 09:46 AM
Most the guides are same for SG Models, Cisco do not write documentation for every model if they have same proceedures.
May be you can connect Laptop to Port and see if you get DHCP IP from switch to go for quick start config as mentioned config.
Still issue contact Cisco TAC.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide