Not getting user ip addresses in Top-Talkers

[therockyankur001]

Hello,

I'm facing problem while getting users details after enabling top-talkers on my Cisco 1941 Router.

Output showing multiple Access point as source & WLC as a destination.

So i want to know if there is any way i can get actual users & destination details.

Top-talkers are properly enable on my router.

Lan interface :- IP FLOW INGRESS

WAN interface :- IP FLOW EGRESS

Thanks in advance for quick response.

[Flavio Miranda]

Hi @therockyankur001

 As you said you have AP and WLC you may not see the information because the communication between AP and WLC run inside a secure tunnel. Consequently, the clients communication as well.

 If that is the case, you can try work with netflow on the WLC directly and then gather information about application on your network.

-If I helped you somehow, please, rate it as useful.-