Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
495
Views
0
Helpful
2
Replies

PI 2.1 Image Distribution across NAT boundary fails

Go to solution
Seth Bjorn
Level 1
Level 1

‎07-25-2014 11:34 AM

I cannot distribution images to network devices across a NAT boundary. I believe PI is using it's private IP address for the copy commands. Is there any way to change that to it's NAT address?

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
AFROJ AHMAD
Cisco Employee
Cisco Employee

‎07-25-2014 04:48 PM

Hi Seth,

AFAIK, NAT is still not supported in PI ,however this is in the raod map.

 

Thanks-

Afroz

***Ratings Encourages Contributors ***
 

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****

View solution in original post

0 Helpful
2 Replies 2

Go to solution
AFROJ AHMAD
Cisco Employee
Cisco Employee

‎07-25-2014 04:48 PM

Hi Seth,

AFAIK, NAT is still not supported in PI ,however this is in the raod map.

 

Thanks-

Afroz

***Ratings Encourages Contributors ***
 

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
0 Helpful

Go to solution
Seth Bjorn
Level 1
Level 1

‎07-28-2014 09:32 AM

Bummer, ok. Is there any way I could get a look at the roadmap?

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents