05-13-2015 03:03 AM
Dear Community,
I have a small site with one Cisco892FSP (IOS 15.5T2) with a lot of connected clients to its 8-port switch. I successfully added the router/switch to PI2.2 (managed). The SNMP config on router is quite easy with SNMPv2 enabled and a RW community.
The problem is that the clients don't show up under "Monitor->Clients and Users". It is just empty.
- Which MIB does PI use to get clients and users? Maybe it is not supported on routers?
- Any other idea?
Regards
06-01-2015 04:17 AM
Hi ,
Go to Admin >background task and make sure "Wired Client Status" is ENABLED
Thanks-
Afroz
***Ratings Encourages Contributors ***
06-01-2015 05:07 AM
06-01-2015 05:14 AM
How about the client statics for other devices like switches ?
06-01-2015 06:50 AM
06-01-2015 09:19 AM
as far as I know ,client and user information will not work for router :(
Thanks-
Afroz
***Ratings Encourages Contributors ***
Thanks-
Afroz
***Ratings Encourages Contributors ***
- See more at: https://supportforums.cisco.com/discussion/12505971/pi-22-c892-clients-and-users-not-monitored#sthash.pe4sVZUR.dpufThanks-
Afroz
***Ratings Encourages Contributors ***
- See more at: https://supportforums.cisco.com/discussion/12505971/pi-22-c892-clients-and-users-not-monitored#sthash.pe4sVZUR.dpuf
Thanks-
Afroz
***Ratings Encourages Contributors ***
- See more at: https://supportforums.cisco.com/discussion/12505971/pi-22-c892-clients-and-users-not-monitored#sthash.pe4sVZUR.dpufDiscover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide