cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

PI 3.1.3 why unsupported cisco device?

Kevin Homistek
Beginner
Beginner

Hello, I have several Catalyst 6824 devices, that show up in Inventory as managed, but device type is "Unsupported Cisco Device" - TAC case has been open since 9/2/16 on this issue - also just loaded DP4 this morning but didn't help. Anyone out there managing these switches using PI 3.x?

Below is a partial sh ver from one of the systems - they're all the same:

System image file is "bootdisk:/c6848x-adventerprisek9-mz.SPA.152-2.SY1.bin"

Cisco C6824-X-LE-40G ( Intel(R) Pentium(R) CPU @ 2.00GHz ) processor (revision ) with 2994175K/409600K bytes of memory.
Processor board ID FDO1932L02A
Processor signature 0xA9060300
Last reset from power-on
1 Virtual Ethernet interface
1 Gigabit Ethernet interface
24 Ten Gigabit Ethernet interfaces
2 Forty Gigabit Ethernet interfaces
1955824K bytes of USB Flash bootdisk (Read/Write)

Thanks,

Kevin

17 REPLIES 17

According to Cisco's supported device list, prime does support the Catalyst 68xx in VSS mode.  We have several C6824-X-LE-40G devices setup in VSS mode that we manage in Prime.

 

I found out today through a TAC case as many on this thread have stated - the 6824-X is not supported as a standalone device.

 

Very odd situation:

Standalone = not supported

VSS = supported.

We are on 3.4.1 -- Device pack 7 fixed the issue and now our standalone 6824s are fully supported. ~26 months since my original post here and multiple TAC cases, but it's better late than never!

Wow ... over 2 years for Cisco to get this resolved, seems like quite a long time.  I am glad to see Cisco took input from customers and made this happen.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: