10-06-2020 07:21 AM
Hi guys,
I'm at the setup phase of configuring my network and could use some assistance as this is the first time I've done Policy Binding.
I have a Dual WAN setup; WAN 1 is Xplornet @ 60 Mbps down and 3 Mbps up and WAN 2 is Bell Mobility LTE (via a Microhard BulletCAT9) @ 50 Mbps down and about 20 Mbps up.
The Bell service has the fastest upload speed, but expensive data cost. The Xplornet service has the greater download speed with unlimited data usage.
So, my issue (wont) is more about data usage rather than simple load balancing.
I want to use the Bell service for upload and Xplornet for down, right across my network which has 6 computers on the LAN.
Is this possible and further, how do I configure it moving forward?
Appreciate your assistance
The T-Man
10-06-2020 10:46 AM
Short answer NO - with a basic static route.
Asymmetric only possible with BGP TE
But as per thinking, you want to use only for upload traffic file, you can use PBR marking.
I believe you want to send traffic out using ISP1 and get the Traffic ISP2 (then answer NO)
10-06-2020 02:35 PM
10-06-2020 02:49 PM
I am not a big user of RV Series,
As per the document - Multi-WAN ( you can have policy binding based on source and service to send WAN Link, is that works?
10-06-2020 03:11 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide