After configuring an IPSec gateway to gateway of RV320, phase 1 has refused to go through, error from the connecting device PFsense shows that port 500 refused the connection.
My understanding is that port 500 is opened by default on RV320, why is it now refusing connection?
i would check the config again, also check the Logs in RV side ?
***** Rate All Helpful Responses *****
How to Ask The Cisco Community for Help
This is my configuration on both sides
IKE with Preshared key
Local Group Setup
Local Security Gateway Type:
IP Address: 41.
Local Security Group Type:
Remote Group Setup
Remote Security Gateway Type:
Remote Security Group Type:
Phase 1 DH Group:
Group 2 - 1024 bit
Phase 1 Encryption:
Phase 1 Authentication:
Phase 1 SA Lifetime:
sec( Range: 120-86400, Default: 28800 )
Perfect Forward Secrecy:
Phase 2 DH Group:
Phase 2 Encryption:
Phase 2 Authentication:
Phase 2 SA Lifetime:
sec( Range: 120-28800, Default: 3600 )
Minimum Preshared Key Complexity: Enable
Preshared Key Strength Meter:
Keep-Alive, NetBIOS Broadcast and Dead Peer Detection Interval enabled under advanced
and for the process log it shows port 500 is listening on my public IP
Do not understand what the problem might be
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: