cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1314
Views
0
Helpful
1
Replies
Beginner

Port status faulty

Hello,

I am getting port faulty message as shown below. How can I investigate further?

SW02> (enable) show port status 3/26

Port  Name               Status     Vlan       Level  Duplex Speed Type
----- ------------------ ---------- ---------- ------ ------ ----- ------------
3/27                    faulty     22         normal   auto  auto 10/100BaseTX

1 REPLY 1
Highlighted
Collaborator

Re: Port status faulty

Check the cabling, patch panel, the remote end, etc. Replace if necessary. Since this seems to be CatOS, run "show test 3" and maybe "show tech" if it's available, then look through the output.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards