01-18-2017 11:55 AM
Hi,
can someone tell me if there is a specific setting i have to enable that Prime generates automatic links in topology maps ?
In the guide i can only find a section how to set up manual links.
If i view the 360° tab i can see all links the the neigbours.
But 0 Links are showing up in the topology map.
I don't know whats wrong.
01-19-2017 07:59 AM
Hello Christian,
Is CDP enabled on all the inter-switches links ? PI firstly use this protocol to draw automatic links.
Regards,
Abel
01-19-2017 10:36 AM
Hi Abel,
yes CDP was running fine i could see all neigbors. I could not figure out the reason so I did an upgrade to 3.1 now it works fine god knows why.
Regards Christian
01-23-2017 02:47 AM
Hello,
Ok, yes it seems that a lot of bugs were corrected in 3.1.x.
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide