11-30-2017 06:21 AM - edited 03-01-2019 06:17 PM
Hi!
I have Cisco Prime 3.2 in HA. How to switch role from secondary to pirmary using CLI?
Solved! Go to Solution.
11-30-2017 06:37 AM
Hi @User24571
You can access the secondary server on https://
Server :8082
then, you can click in "Failover" bottom.
For detailed explanation, take a look at:
-If I helped you somehow, please, rate it as useful.-
11-30-2017 06:44 AM
From the CLI, you can move the VIP with the following command.
/opt/CSCOlumos/bin/configureVIP.sh primary enable EPNM_Server_IP Virtual_IP_Address
To disable the VIP, you need to use the same command except "disable" instead of "enable".
11-30-2017 06:37 AM
Hi @User24571
You can access the secondary server on https://
Server :8082
then, you can click in "Failover" bottom.
For detailed explanation, take a look at:
-If I helped you somehow, please, rate it as useful.-
11-30-2017 06:44 AM
From the CLI, you can move the VIP with the following command.
/opt/CSCOlumos/bin/configureVIP.sh primary enable EPNM_Server_IP Virtual_IP_Address
To disable the VIP, you need to use the same command except "disable" instead of "enable".
12-01-2017 03:56 AM
Thanks for your help! But I have different question about PRIME and Meraki devices.. Why this Meraki devices are located on PRIME in: Inventory / Group Management / Network Device Groups / Location / All Locations / Unassigned?
I can't move to different location.. :/
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: