Do you know if PI 2.0 supports C1750-Series and C3550s? Before installing Device Update 4.0 they were on the "Device Level Support" list after installing DU4 they disappeared. I am not saying they worked, as they did not ("collection failure" or "partial collection failure"), also there was no minimum IOS mentioned for them, now just vaporized from list.
Have anybody succeeded adding to PI2 C2950? Same problem here. If so what IOS did you had installed on the switch? From Device Support List they should work fine from IOS 12.1.
Can anyone explain or point me to Cisco doc to explain: "collection failure" or "partial collection failure"?
Have you checked what is cause for collection failure or partial collection failure in CPI? You can check that on Device Work Center -> Inventory Collection Status column. Just hover your mouse there until you see small cross-hair icon -> stop you mouse on top of that icon and you'll get pop-up screen telling more details.
Anyway, most of these problems can be checked by downloading inventory.log from CPI server and reviewing all actions what might be causing problems you face.
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...