Prime Infrastructure 2: Device Typ not updated after replacement in Device Work Center
I've found something confusing. Please have a look below. Has anyone the same feature or is familiar with that?
We replaced a 4400-series WLAN controller with a 5500 series controller, the UDI information was discovered correctly but the general information was not updated.
I got it uptodate while exporting exporting the device and doing a bulk import. I also recognized that the credentials were not the correct ones for the new controller. Could it be that the credetial mismatch was cause? Is snmp access not enough to update the inventory information?
Cisco DNA Center version 2.2.2.x includes the features and improvements that
New intelligence provides an easy, gradual, and complete adoption of SD-Access. Faster Cisco DNA Center set-up saves time and effort.
When using Cisco cellular modules with a SIM card an APN must be provided. The APN cannot be stored in the SIM card and is supplied by your SIM card provider. Cisco cellular software contains a database of well-known APNs based on the country and ...
Cisco 3850: IOS-XE/Firmware Upgrade
This procedure is aimed at Cisco 3850 switch ONLY.
IOS-XE Bundle Mode is not covered.
9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered.
Listen: https://smarturl.it/CCRS8E46Follow us: twitter.com/ciscochampionsIt’s been several years since the release of Cisco DNA Center, and it’s matured into a complete network management system, an automation and orchestration engine, an AI/ML analy...
The 2021 IT Blog Awards, hosted by Cisco, is now open for submissions. Submit your blog, vlog or podcast today. For more information, including category details, the process, past winners and FAQs, check out: https://www.cisco.com/c/en/us/t...