07-02-2019 06:25 AM
Hello All,
we have PI 3.5, we have an Access/Dist Tiers.
i am trying to get a notification via eMail only on the Uplinks.
i have created a Port Group - this group including only uplink interfaces.
i have created an alarm - included the Port Group.
at this point, i am trying to configure notification for that alarm, but i do not know where or how to do so,
any ideas?
07-03-2019 07:02 AM
Hi,
Here is a document which will guide, How to configure fault management administration like events, alarms and notifications.
07-05-2019 12:54 AM
is there a way to create a notification from a costume 'Notification Policy"?
i want to create a notification for Uplinks interfaces only.
we have 4506 switches and the notification send an eMail for any interface on that switch.
i want to send a notification only for ports Te1/1 & Te1/2 (Uplinks interfaces).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: