cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2102
Views
0
Helpful
8
Replies

Prime Infrastructure 3.6 - 3.7 Getting slow and cant update or delete.

Hi

On my work we have PI 3.6 installed on our system, we have about 3600 units connected.

Everything is working well, and the suddenly I cant delete units or sync units, it starts to act slow and then the thing happens.

I can then do a NCS stop and NCS cleanup and hope it works, it does in most times and then I can use the system again for a while, and it starts over again.

 

I have made a fresh install on a diff server, with new database, and it is doing the same.

 

Can it be Prime that cant handle so many units?

Is something getting full in the database or?

 

Hope someone can help.

 

PS: Its the same on version 3.7

 

Brian

8 REPLIES 8
marce1000
VIP Mentor

 

                          >Can it be Prime that cant handle so many units?

  Depends , there are different installation-types for Prime , depending on how many network components it has to support. Check the link below - Make sure that your VM has been sized accordingly (if a virtualized-solution is being used). If that is OK, then check your hypervisor-monitoring resources/solutions  and make sure that the VM has sufficient resources (CPU, disk, memory....).

  https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-3/quickstart/guide/bk_Cisco_Prime_Infrastructure_3_3_0_Quick_Start_Guide.html#con_1070021 

 M.

hx. It is on a wmvare, I will check :-)