I have a problem on Prime Infrastructure 3.6 last patch.
For some switches, clients appears for others switches clients don't appears.
I check that there is connected client on theses switches where client don't show up in Prime and mac-address table is not empty for these switch ports.
It happens on different hardware model.
What could be a root cause of that ? My snmpwalk from Prime Infra to switches where I have the problem seems to be correct but I assume that the SSH connection is used to gather the clients mac address table.
I also tried to re-sync these switches, suppress them from my inventory and add them again. I check on my firewall between prime and switches and no one packet is dropped..
Cisco Digital Network Architecture Center Tools <Template Editor > In this article, we are going to talk about the Cisco Digital Network Architecture Center Template Editor tool.Cisco DNA Center gives us the flexibility and scalability to confi...
Community Live- Cisco SD-WAN Policies: Leveraging the Full Power of Cisco SD-WAN
(Live event - formerly known as Webcast- Tuesday 24 March, 2020 at 10 am Pacific/ 1 pm Eastern / 6 pm Paris)
This event had place on Tuesday 24th, March 2020 at 10hrs P...
IS there a way to upgrade the ios on a cisco 9200l switch using a usb drive instead of using a tftp server? If so could someone point me to the article or tell me how this can be done? These switches seem to be more complicated than previous switches. Tha...
Hello,I'm needing to integrate the Cisco Firepower 2110 into our Data Center JUST to fulfill Site-to-Site and Remote Access VPN. My SD-WAN ISRs already have FW and IPS running, which is what I want since I have internet breakouts at my branches, so this D...
Hi, Switch 1 and switch 2 connected via trunk. Both configured with new vlan 3.When creating new vlan 3, is it need to include "Spanning-tree vlan 3 priority 8192"- Sw 1 and "Spanning-tree vlan 3 priority 16384"-Sw 2?What will happen for those s...