Prime Infrastructure 3.7 PoE Report

[mfilser]

Hi all.

With older versions of LMS or PI (I'm not shure, but I've seen it up to PI 3.2) there was a possibility to create a report for all PoE-enabled Ports.

My customer was asking about the usage of his PoE-Ports.

He wants to know:

1. Which port is PoE enabled?

2. How much energy the port is consuming?

3. What kind of device is connected with this port?

In the newer Versions of PI (3.7 / 3.8) I'm missing these reports.

Is there a possibility to create a custom report with all these information with PI 3.7?

Thanks in advance

Markus

[marce1000 · Accepted solution]

 - Following this thread , seems possibilities are still limited or none :

          https://community.cisco.com/t5/network-management/how-to-pull-bulk-poe-information-from-many-switches/td-p/3396448

 M.