cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1803
Views
0
Helpful
1
Replies

Prime Infrastructure 3.7 PoE Report

mfilser
Beginner
Beginner

Hi all.

 

With older versions of LMS or PI (I'm not shure, but I've seen it up to PI 3.2) there was a possibility to create a report for all PoE-enabled Ports.

 

My customer was asking about the usage of his PoE-Ports.

He wants to know:

1. Which port is PoE enabled?

2. How much energy the port is consuming?

3. What kind of device is connected with this port?

 

In the newer Versions of PI (3.7 / 3.8) I'm missing these reports.

Is there a possibility to create a custom report with all these information with PI 3.7?

 

Thanks in advance

 

Markus

 

1 Accepted Solution

Accepted Solutions

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

 - Following this thread , seems possibilities are still limited or none :

          https://community.cisco.com/t5/network-management/how-to-pull-bulk-poe-information-from-many-switches/td-p/3396448

 M.

View solution in original post

1 Reply 1

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

 - Following this thread , seems possibilities are still limited or none :

          https://community.cisco.com/t5/network-management/how-to-pull-bulk-poe-information-from-many-switches/td-p/3396448

 M.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: