cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2681
Views
0
Helpful
1
Replies

Prime Infrastructure 3.7 PoE Report

mfilser
Level 1
Level 1

Hi all.

 

With older versions of LMS or PI (I'm not shure, but I've seen it up to PI 3.2) there was a possibility to create a report for all PoE-enabled Ports.

 

My customer was asking about the usage of his PoE-Ports.

He wants to know:

1. Which port is PoE enabled?

2. How much energy the port is consuming?

3. What kind of device is connected with this port?

 

In the newer Versions of PI (3.7 / 3.8) I'm missing these reports.

Is there a possibility to create a custom report with all these information with PI 3.7?

 

Thanks in advance

 

Markus

 

1 Accepted Solution

Accepted Solutions

marce1000
Hall of Fame
Hall of Fame

 

 - Following this thread , seems possibilities are still limited or none :

          https://community.cisco.com/t5/network-management/how-to-pull-bulk-poe-information-from-many-switches/td-p/3396448

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

View solution in original post

1 Reply 1

marce1000
Hall of Fame
Hall of Fame

 

 - Following this thread , seems possibilities are still limited or none :

          https://community.cisco.com/t5/network-management/how-to-pull-bulk-poe-information-from-many-switches/td-p/3396448

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '