11-10-2014 02:14 PM
In the "Cisco Prime Infrastructure 2.0 User Guide" it states:
Prime Infrastructure logs all emergency, alert, and critical messages generated by all devices that are
managed by Prime Infrastructure.
Prime Infrastructure also logs all SNMP messages and syslogs it receives. To view syslogs, choose
Operate > Alarms & Events, then click the Syslogs tab.
Syslog Pre-defined Filters
Prime Infrastructure uses the following syslog filters:
• Severity 0 and 1
• Severity 2
• Environmental Monitor
• Memory Allocation Failure
• Catalyst Integrated Security Features
• Cisco IOS Firewall Denial of Service
Can this be changed or is this Pre-defined filter something I have to live with? If it can be changed, where? The user guide doesn't get into it (at least not that I could find).
Thanks
Solved! Go to Solution.
11-10-2014 05:21 PM
Hi ,
Directly only sev 0,1 and 2 syslogs are supported in PI 2.x so far.
but you can edit a properties file and get it working for other severity as well.
check the below link:
https://supportforums.cisco.com/discussion/11645481/prime-infrastructure-12-syslog
hope it will answer your query.
Thanks-
Afroz
****Ratings Encourages Contributors ****
11-10-2014 05:21 PM
Hi ,
Directly only sev 0,1 and 2 syslogs are supported in PI 2.x so far.
but you can edit a properties file and get it working for other severity as well.
check the below link:
https://supportforums.cisco.com/discussion/11645481/prime-infrastructure-12-syslog
hope it will answer your query.
Thanks-
Afroz
****Ratings Encourages Contributors ****
11-12-2014 01:04 PM
Thanks!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: