Prime Infrastructure: command to change standalone server to secondary server (for HA)

[SSC Micron]

Primes are supposed to be installed in 2 different servers: 1 primary, 1 secondary for redundancy.

However, the second Prime was accidentally installed as a stand alone server. Hence, it could not register with the primary one.

May I know if there is any way or any command to switch the second Prime from stand alone to secondary in HA mode. Or I need to reinstall Prime from the OVA file?

[Marvin Rhoads · Accepted solution]

The supported method is to specify the role during installation. (Reference)

You might be able to re-initialize the db and re-run setup but I would strongly advise restarting with a clean installation to maximize your probability of success.