cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1092
Views
0
Helpful
8
Replies
Highlighted

Prime LMS 4.2.1 - Switch Ports in Errdisable

                   Hi All,

on a 4.2.1 LMS installation, switch ports that have port security configured and there happens a violation, thus going into errdisable mode, DO NOT show any alarms on the dashboard. Therefore we don't see any errdisabled ports listed.

Has anyone seen this before?

Thank you,

George

8 REPLIES 8
Highlighted
Participant

what is your schedule for faulty discovery ?

are the device managed ?

Highlighted

Fault discovery uses the defaults. On another installation for another customer this works fine. Additionally, this is a trap sent by the device to the LMS so no need for fault discovery. Also, the debugs for the device site show that the meesages are being generated and sent to the LMS over the SNMP.

The device is a 4507R+E-SUP7L.

Any more thoughts?

Highlighted
Hall of Fame Guru

It should generally work. I have an LMS 4.2.1 installation that definitely shows errrdisable ports on the main dashboard (and relevant submenus).

Highlighted

Yes I know, on another installation for another customer this works fine.

Any more suggestions?

Thanks

Highlighted

update device packages

might be new for c4500

did you give reload a  try ?

/etc/init.d/dmgtd stop

...

/etc/init.d/dmgtd start

if its on windows, you have several other possible options as to why your UDP/162 trap gets dropped ?

HTH

Highlighted

Device packages already up to date.

Reload already done.

LMS and device on the same mgmt VLAN, no ACLs and/or firewall/AV whatsoever...

Highlighted

Do you have the correct snmp trap configured on your 4507? Something like

snmp-server enable traps errdisable

regards,

Craig

Highlighted

Hi Craig,

thanks for replying.

Yes I have the trap configured. Any more suggestions?

Cheers.

Content for Community-Ad