on a 4.2.1 LMS installation, switch ports that have port security configured and there happens a violation, thus going into errdisable mode, DO NOT show any alarms on the dashboard. Therefore we don't see any errdisabled ports listed.
Has anyone seen this before?
Fault discovery uses the defaults. On another installation for another customer this works fine. Additionally, this is a trap sent by the device to the LMS so no need for fault discovery. Also, the debugs for the device site show that the meesages are being generated and sent to the LMS over the SNMP.
The device is a 4507R+E-SUP7L.
Any more thoughts?
update device packages
might be new for c4500
did you give reload a try ?
if its on windows, you have several other possible options as to why your UDP/162 trap gets dropped ?