Prime LMS 4.2.5 - CheckPoint R75.40 Upload mib's.

[Dawit Zeru]

Hi All,

here is my issue.

In my DMZ environment the L3 and DG is the CheckPoint R75.40, we successfully discover the CP as non-cisco.

when I'm running a report on the CP R75.40 let's say 'Interpreting Medianet Endpoint Inventory Report' I don't get any result.

after contacting CP TAC they send me MIB's to upload to the LMS I tried to upload them but no success there.

I was trying to generate a report that can show me LAST SEEN, but without any success.

can someone please explain to me or answer:

1. to which MIB category the 'last seen' belong? is it to the ARP table?

2. how can I upload the MIB's?

3. can the LMS collect the TABLES from non-cisco or third party device by default, and if not how can it be supported?

thanks in advance.

[Ernesto Q · Accepted solution]

Hello Dawit,

To answer question #2 regarding uploading/adding MIBs to LMS, the link below might help you:

http://www.cisco.com/c/en/us/td/docs/net_mgmt/ciscoworks_lan_management_solution/4-2/user/guide/admin/admin/monitor.html#pgfId-1098322

As for question #3, the best information regarding the LMS support for non-cisco devices can be found below:

http://www.cisco.com/c/en/us/td/docs/net_mgmt/ciscoworks_lan_management_solution/4-2/user/guide/inventory/inventory/dcr.html#wp1053037

As you can see LMS has very limited support when it comes to non-cisco devices.

Hope such information helps you on this matter.

Regards,

Ernesto Q

***Ratings Encourages Contributors ***