cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
676
Views
0
Helpful
1
Replies

Problem after upgrading from 4.2 to 4.2.2

gary.whitaker
Level 1
Level 1

I just recently did an upgrade from 4.2 to 4.2.2 running on an Appliance. After the upgrade all the services do not load up. Running a "show app status LMS" always comes up with a message saying daemon manager is not fully intialized. The DCRServer process is just hanging with the status "waiting to initialize".                 

I am able to GUI in but can't use view any of the managed devices due to DCRServer in a hung state. I have restared LMS application multiple times. I have stopped LMS application and then reloaded the box. The issue still keeps occuring, im going to raise a TAC case but was wondering if anyone else has come across this issue?

1 Reply 1

AFROJ AHMAD
Cisco Employee
Cisco Employee

Are you still facing the above issue ?

If yes send me the below information.

output of pdshow

ctm_config.txt  from the below location:

NMSROOT\CSCOpx\MDC\tomcat\lib

NMSROOT\CSCOpx\MDC\tomcat\shared\lib

NMSROOT\CSCOpx\MDC\tomcat\webapps\cwhp\WEB-INF\lib

Also md.properties and Regdaemon.xml

Thanks

Afroz

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: