cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
426
Views
5
Helpful
1
Replies

Problem with .0 ip address and IPM

Hi,I've installed IPM 2.6 and I've to import a set of target hosts.

There are some ip address like 172.16.x.0/32 and other like 172.16.x.1/32

I notice that only the routers with L0 IP address like 172.16.x.1/32 are loaded into IPM.

All the configuration on the firewalls and snmp are right.

Is it possible that IPM doesn't load a router with ip address like 172.16.x.0 /32?

Antonio

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

That is correct. IPM 2.6 has a hardcoded check to make sure the last octet is not 255 or 0. IPM 2.x was created when /32 loopback addresses was not possible, and is entering end of life status. Such addresses are supported in IPM 4.x. I suggest you look into upgrading to LMS 3.0 or higher.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco