cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2469
Views
0
Helpful
2
Replies
Highlighted
Beginner

procedure of putting MIB in cisco switches !!!!!!!!

Hi,

I want to generate below traps and for that i need to put a particular mib RADIUS-AUTH-CLIENT-MIB on the switch. Can anyone tell me the procedure of putting mib directly on cisco switch.

RADIUS: Received from id 1645/167 10.1.10.6:1812, Access-Reject, len 44

Regards,

Ahsan Khan.

2 REPLIES 2
Highlighted
Collaborator

it is not possible to compile or "put" a MIB file into a Cisco switch.

The supported MIBs are compiled within the IOS. Have a look here to see which IOS supports which MIBs:

http://tools.cisco.com/ITDIT/MIBS/MainServlet

http://tools.cisco.com/ITDIT/MIBS/servlet/index

Highlighted
Beginner

Hi Ahsan,

 

make sure to correctly understand how SNMP works.

 

- A SNMP-Agent (e.g. located on a Cisco switch) is able to send SNMP-Traps being configured.
  (Available traps are hardcoded in the agent)

- A MIB is simply a (virtual) description of available variables and traps

- Each Agent has its own set of supported MIB-Variables ( use #show snmp mib for getting an
  overview of supported Vars on that switch)

  Please have a look at MIB Navigator on cisco.com (http://tools.cisco.com/ITDIT/MIBS/MainServlet )

- You primary 'install' MIBs on the SNMP-Manager getting access to the hardcoded SNMP-Variables
   and to display SNMP-Agent-Traps correctly

 

Hope this helps

 

Lothar

Content for Community-Ad