10-07-2013 05:40 AM
Hi,
I want to generate below traps and for that i need to put a particular mib RADIUS-AUTH-CLIENT-MIB on the switch. Can anyone tell me the procedure of putting mib directly on cisco switch.
RADIUS: Received from id 1645/167 10.1.10.6:1812, Access-Reject, len 44
Regards,
Ahsan Khan.
10-07-2013 09:05 AM
it is not possible to compile or "put" a MIB file into a Cisco switch.
The supported MIBs are compiled within the IOS. Have a look here to see which IOS supports which MIBs:
07-28-2014 11:11 PM
Hi Ahsan,
make sure to correctly understand how SNMP works.
- A SNMP-Agent (e.g. located on a Cisco switch) is able to send SNMP-Traps being configured.
(Available traps are hardcoded in the agent)
- A MIB is simply a (virtual) description of available variables and traps
- Each Agent has its own set of supported MIB-Variables ( use #show snmp mib
for getting an
overview of supported Vars on that switch)
Please have a look at MIB Navigator on cisco.com (http://tools.cisco.com/ITDIT/MIBS/MainServlet )
- You primary 'install' MIBs on the SNMP-Manager getting access to the hardcoded SNMP-Variables
and to display SNMP-Agent-Traps correctly
Hope this helps
Lothar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: