cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
970
Views
2
Helpful
1
Replies

Removing Communities from CNA

thomascollins
Level 3
Level 3

Hello,

Using CNA 4.0. I have a lot of communities I've created, and they all show up at the "Connect To" dialog box that opens when you start CNA.

Is there a way to remove devices/communities from that list? I have some that are no longer needed.

I know I can edit my communities (and even delete them) from Application | Communities. But they still show up on the "Connect To" drop down list at startup.

Thanks,

Tom

1 Reply 1

troystandefer
Level 1
Level 1

I had the same problem. I searched my C drive for the files and folders named community and deleted all of the files and folders in it. I don't remember exactly where it was. After deleting the files the communities were gone in CNA. Hope this helps.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco