Did you upgraded the existing LMS 4.1 to 4.2 or made a new LMS 4.2 server? Does the new LMS 4.2 server has IP/Hostname configured properly.
CSTM attempts to determine if a request is a local request by looking up the hostname of the server, and obtaining all of the associated IP addresses with that hostname. The second method to determine locality is the same as previously mentioned, but starts with 127.0.0.1, gets the associated hostname (usually localhost), then looks up localhost to get all the associated IPs.
So if you are using the a multihomed server, or virtual IP addresses, this might break the operation in DCR. Also if the hostname is not configured correctly in LMS, the same problem will occur.
To fix these break points, you need to make sure that all IP addresses being used on the server are pointing to its hostname, you need to add them to the /etc/hosts:
10.230.150.200 x0669e00 x0669e00.bk.datev.de
Also, LMS has several places where it stores the servers hostname , you can make sure that LMS is using the correct hostname by using the script:
Old_ Hostname -Old Hostname of the CiscoWorks Server (the incorrect x0669) New_Hostname -New Hostname of the CiscoWorks Server (x0669e00) Domain -Domain name of the CiscoWorks Server. Entering domain name is optional.
Please make sure that you go through all the prerequisites and steps required to run this script which are mentioned here:
I experienced a similair problem when upgrading my LMS 4.1 system to LMS 4.2. This was on a soft appliance where the LMS 4.2 installation was a new clean install where I wanted to restore the backup from my old LMS 4.1.
Just like you it stopped at 70% on RME restore and I got the same "loop" in the log like you did.
In my case however I resolved it by just running the restore once again after the first one had failed (no changes made to the system). I still got the "loop" in the restore log but this time the restore continued and successfully completed both the RME restore and all remaining parts of the installation.
Just my two cents but it might be worth a try for you too if you're still having this problem.
Help us make the Cisco smart building solutions more useful for your industry.
Let us know how important these solutions are to your company by answering this short 4-question survey (your responses will remain completely anonymous).
Please take a minute...
Introduction to Routing ProtocolsStatic vs DynamicDistance Vector vs Link StateRoute Selection AlgorithmSingle Routing Protocol OnlyOpen Shortest Path First (OSPF)AreasRoute ConvergencePath SelectionMetric CalculationCharacteristicsEnhanced Interior Gatew...
Cisco DNA Center version 2.2.2.x includes the features and improvements that
New intelligence provides an easy, gradual, and complete adoption of SD-Access. Faster Cisco DNA Center set-up saves time and effort.
When using Cisco cellular modules with a SIM card an APN must be provided. The APN cannot be stored in the SIM card and is supplied by your SIM card provider. Cisco cellular software contains a database of well-known APNs based on the country and ...
Cisco 3850: IOS-XE/Firmware Upgrade
This procedure is aimed at Cisco 3850 switch ONLY.
IOS-XE Bundle Mode is not covered.
9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered.