cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

251
Views
0
Helpful
1
Replies
Beginner

RME 4.0.5 - FWSM with multiple context - config archive

Hi all

Is it possible to make config archive from multiple context FWSM with RME in CiscoWorks?

RME reports config archive successful and Debug has no errors. RME is successfully making config archive from one context and the system context. It seems not to notice the other contexts.

The Device in question:

Cisco Catalyst 6000 FWSM (Multiple Security Contexts)

Current setup:

LMS 2.6

RME 4.0.5 + Catalyst 6000 IOS Switch Series Package.

Any suggestions or ideas?

Regards

Andri

1 REPLY 1
Collaborator

Re: RME 4.0.5 - FWSM with multiple context - config archive

There's a footnote on that:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.0.3/device_support/table/RME403SI.htm

"5. After adding the device into the DCR, and whenever the device is switched between the Single and Multi Security Context Modes, the device should be deleted and added again into the DCR. This is due to change in the sysobjid and also because the number of configurations for the device varies when there is switching between the modes."

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards