Hi, I have a problem with RME 4.2 from CWLMS 3.1. I have configured SSH in my asa 5520 device but RME can't get the configuration file.
I ran a job to sync archive but i get this message error:
*** Device Details for ASA_5520_VOZ_01 *** Protocol ==> Unknown / Not Applicable Selected Protocols with order ==> Telnet,TFTP,SSH Execution Result: CM0062 Polling ASA_5520_VOZ_01 for changes to configuration. CM00 Polling not supported on PRIMARY STARTUP config, defaulting to fetch. CM00 Polling not supported on PRIMARY RUNNING config, defaulting to fetch.
STARTUP CM0151 PRIMARY STARTUP Config fetch failed for ASA_5520_VOZ_01 Cause: TELNET: Failed to establish TELNET connection to 10.225.177.36 - Cause: Connection refused. Failed to get the start tag-: in the configuration. Action: Check if protocol is supported by device and required device package is installed. Check device credentials. Increase timeout value, if required. RUNNING CM0151 PRIMARY RUNNING Config fetch failed for ASA_5520_VOZ_01 Cause: TELNET: Failed to establish TELNET connection to 10.225.177.36 - Cause: Connection refused.
Could not detect SSH protocols running on the device
Action: Check if protocol is supported by device and required device package is installed. Check device credentials. Increase timeout value, if required.
I only have configured ssh because telnet is not permited.
I am having a similar problem. Looking at the dcmaservice.log the LMS server is trying to connect to a different IP address on the firewall (the outside ip address which is higher than the inside ip address). the LMS server is not using the IP address that was configured when the device was added. Inventory and credentials checking works fine. How can I change it so that the RME module uses the configured IP address not one it selects based on some definition I cannot find?
Firewall rules are blocking accessing the ASA via the IP address that RME picked.
Cisco DNA Center version 2.2.2.x includes the features and improvements that
New intelligence provides an easy, gradual, and complete adoption of SD-Access. Faster Cisco DNA Center set-up saves time and effort.
When using Cisco cellular modules with a SIM card an APN must be provided. The APN cannot be stored in the SIM card and is supplied by your SIM card provider. Cisco cellular software contains a database of well-known APNs based on the country and ...
Cisco 3850: IOS-XE/Firmware Upgrade
This procedure is aimed at Cisco 3850 switch ONLY.
IOS-XE Bundle Mode is not covered.
9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered.
Listen: https://smarturl.it/CCRS8E46Follow us: twitter.com/ciscochampionsIt’s been several years since the release of Cisco DNA Center, and it’s matured into a complete network management system, an automation and orchestration engine, an AI/ML analy...
The 2021 IT Blog Awards, hosted by Cisco, is now open for submissions. Submit your blog, vlog or podcast today. For more information, including category details, the process, past winners and FAQs, check out: https://www.cisco.com/c/en/us/t...